Stainless Steel Deep Groove Ball Bearing SS 6800 / 61800 2RS C3 GF1 10x19x5 mm
Item number:
SS-6800-2RS-C3-GF1
Item features:
Very narrow, very light and with extremely good spinning characteristics. The stainless steel deep groove ball bearing SS-6800-2RS-C3-GF1 is very narrow, can also be used with limited space and is resistant to corrosion.
Technical ScribbleZoomable
Technical Data
Inside Ø (mm): | 10 |
Outside Ø (mm): | 19 |
Width (mm): | 5 |
Tolerance for inside-Ø (mm): | 0/-0,008 |
Tolerance for outside-Ø (mm): | 0/-0,009 |
Tolerance for width (mm): | 0/-0,12 |
Bore: | cylindrical |
Extended Inner Ring: | no |
Seal: | 2RS |
Sealing material: | NBR |
Ring Material: | Stainless Steel |
Rolling Element Material: | Stainless Steel |
Cage Material: | Stainless Steel |
Type of lubrication: | greased |
Lubrication: | Mobilgrease FM 222 (suitable for the food sector) |
Lifetime lubricated: | yes |
Seal Colour: | Blue |
Internal Clearance: | C3 (increased clearance) |
Tolerance Class: | ABEC 1 / P0 |
Noise and vibration testing: | Class V |
max. Operating Temperature: | +100°C (briefly up to +120°C) |
min. Operating Temperature: | -20°C |
Magnetic: | yes |
Norm: | DIN 625-1 |
Item weight: | 5 g |
Features
- all components are made of stainless steel: the deep groove ball bearing has therefore good corrosion resistance to mild media (e.g. fresh water) and is hygienic
- thin section bearing with a very thin cross section
- suitable for space-saving installation in radial and axial directions
- extra light series with compact dimensions and low weight
- suitable for radial loads and light axial loads in both directions
- offers high running accuracy
- seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect
- If you need this bearing in RS design with only one seal and one open side, you can simply remove one of the two seals: to the instructions
- Lubrication: Mobilgrease FM 222. This grease is registered with NFS as H1-Lubricant and is therefore approved for the food sector.
- with increased radial internal clearance (C3): for high temperature gradient between the bearing rings or for fastening with press fit
- good fixed bearing property, but can also be used as a floating bearing, each in both directions
- manufacturers of bearings, such as FAG, KOYO, NSK, SKF, SNR, etc. assign different suffixes for their characteristics, for better orientation take note of the comparison table of bearings (see further information)
Further Information
- What does radial and axial load capacity mean?
- Fit recommendations for mounting
- Info sheet ball bearing
- Information about ball bearing seals
- Internal clearance and operating clearance
- Comparison list of roller bearings
- Comparison of features of roller bearings
- How do I clean my bearings?
- How do I grease or oil my bearings?
- Are bearings made of stainless steel 100 per cent corrosion-resistant?
- Can bearings made of stainless steel be magnetic?
- How do I remove a sealing washer or cover plate?