Englisch
Deutsch
Miniature Pillow Block Housing Unit KP08 - Shaft: 8 mm (Silver-Series)
Item number: KP08
Item features:
The miniature pillow block bearing KP08 is suitable for particularly small shaft diameters and high radial loads. The housing is made of zinc die-cast and sturdy.
Technical ScribbleZoomable
Technical Data
| Inside Ø (mm): | 8 |
| Tolerance for inside-Ø (mm): | 0,015/0 |
| Tolerance for width L (mm): | 0/-0,12 |
| Housing Type: | Plummer block bearing |
| Shaft Fastening: | Grub Screws |
| Number of Mounting Holes: | 2 |
| Ring Material: | Rolling Bearing Steel |
| Rolling Element Material: | Rolling Bearing Steel |
| Housing Material: | Zinc Die-Cast |
| Cage Material: | Sheet Steel |
| Type of lubrication: | greased |
| Lifetime lubricated: | yes |
| Recommended tightening torque for shaft fastener (Nm): | 1.5 |
| Bearing No.: | K 08 |
| Housing No.: | P 08 |
| Grub Screw: | M4 |
| max. Operating Temperature: | +100°C (briefly up to +120°C) |
| min. Operating Temperature: | -20°C |
| Norm: | DIN 625-4 |
| Item weight: | 37 g |
Features
- consisting of a ball bearing insert K 08 and a zinc die-cast housing P 08
- suitable for mounting on flat surfaces and high radial load capacities
- the housing is made of zinc die-cast
- the bearing insert has an extended inner ring with grub screws
- The pillow block bearing is mounted on the shaft with two grub screws
- the bearing insert can compensate for low static misalignment
- two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter
- lubricated for life; under normal operating conditions relubrication is not required
- In addition to this article, we can also offer bearings of the brands FAG, KOYO, NSK, SKF, SNR, etc. on request.
Further Information
Dimensions
Customer Ratings
Entries 1 – 5 of 7
Entries 1 – 5 of 7