Fit system for drawn cup roller clutches
Recommended fit for the shaft
Series | Spring material |
Shaft tolerance for high loads |
Shaft tolerance for low loads (Md perm < 50%) |
---|---|---|---|
HF, HFL | steel | h5 | h6 |
HF..-KF, HFL..-KF | plastic | h8 | — |
HF..-R, HFL..-R | steel | h5 | h6 |
HF..-KFR, HFL..-KRF | plastic | h8 | — |
HFL0606-KFR, HFL0806-KFR | plastic | h9 | — |
Md perm = permissible torque |
Recommended fit for the bore
Series | Spring material |
Tolerance for Steel, cast iron high load / low load (Md perm < 50%) |
bore tolerance for light metal high load / low load (Md perm < 50%) |
max. Ø in plastic |
---|---|---|---|---|
HF, HFL | steel | N6 / (N7) | R6 / (R7) | — |
HF..-KF, HFL..-KF | plastic | N7 | R7 | — |
HF..-R, HFL..-R | steel | — | — | D-0,05 mm |
HF..-KFR, HFL..-KRF | plastic | — | — | D-0,05 mm |
HFL0606-KFR, HFL0806-KFR | plastic | — | — | D-0,05 mm |
Md perm = permissible torque |
This information is to be seen as a recommendation. The data has been carefully compiled from various sources, but no guarantee is given for any information.